# System Settings

## Start Setup
```{note}
Only after scanning [Start Setup](#start-setup-figure) can you scan other function setup codes for configuration. You need to scan [End Setup](#end-setup-figure) for the corresponding configuration to take effect.
```
```{figure} ../../media/252B24.24.png
:align: center
:width: 300px
:name: start-setup-figure

Start Setup
```

## Restore Default Settings
When an unknown error occurs on the scanner, you can reset the scanner by restoring the default settings.


```{figure} ../../media/252B2B25.png
:align: center
:width: 300px

Restore Default Settings
```



## Volume Settings

### Enable

```{figure} ../../media/SND1.png
:align: center
:width: 300px

`*` Enable
```
  
### Disable
```{figure} ../../media/SND0.png
:align: center
:width: 300px

Disable
```


## End Setup
```{note}
Only after scanning [Start Setup](#start-setup-figure) can you scan other function setup codes for configuration. You need to scan [End Setup](#end-setup-figure) for the corresponding configuration to take effect.
```

```{figure} ../../media/25242425.png
:align: center
:width: 300px
:name: end-setup-figure

End Setup
```